3MTLX10
Overview
The 3MTLX10 gauging transducer is manufactured to a superior mechanical standard, ensuring low nonrepeatability and a measurement performance difficult to match in this type of product.
Photograph
Basic Specifications
|
Calibrated range |
+/- 1 mm |
|
Total travel |
2.5 mm |
|
Sensitivity |
73 mV/V/mm into 2 kOhm |
Features
-
Precision Manufacture
-
High Accuracy
-
Half Bridge
-
CE Marking
-
Repairable
Connectivity:
These transducers are supplied with two meters of black oil-resistant cable terminated into a five-pin 270 degree DIN connector as standard. Alternative connectors may be specified at the time of ordering.
Calibration:
Calibration components are mounted on a small PCB within the connector housing, this PCB can be replaced by a network of components should custom connectors be required. Calibration is carried out using a computer controlled process and high-precision optical encoders. A calibration certificate can be supplied on request.
Other:
Pre-travel is factory set and not adjustable. Both pneumatic push and vacuum retract options are available. All TLX transducers carry the CE mark and are protected to IP64.
Detailed Specifications
|
Transducer type
|
3TLX10A = axial cable exit
|
|
|
3TLX10R = radial cable exit
|
|
|
3TLX10RV = vacuum retract
|
|
|
3TLX10RP = pneumatic push
|
|
Configuration
|
half bridge
|
|
Mechanical travel
|
[see specifications on previous page]
|
|
Calibrated range
|
[see specifications on previous page]
|
|
Sensitivity (standarized)
|
[see specifications on previous page]
|
|
Connector
|
DIN 5 pin 2700 or as requested
|
|
Linearity
|
better than 0.3% of total stroke bsl
|
|
Repeatability
|
0.02 um
|
|
Residual at zero
|
less than 3 mV
|
|
Carrier frequency
|
10 kHz and 13 kHz
|
|
Energising voltage
|
1 - 10 V rms
|
|
Bearing type
|
linear ball
|
|
Minimum life
|
10 million cycles
|
|
Moving mass
|
6 grams
|
|
Anti-rotation
|
maximum 1 degree over full travel
|
|
Temperature range
|
+14º F to +149º F storage and service
|
|
Mounting position
|
any position
|
|
Ball tip
|
Special tip M2 with 2 mm tungsten ball
|
|
Gaiter material
|
Viton rubber green
|
|
Cable
|
Black 4 core screened 2 m
|
|
Spring force
|
0.4 N at electrical zero
|
|
|
(option 0.25 - 4 N)
|
|
Pre-travel
|
Adjustable
|
|
Protection class
|
IP64
|
PDF ENGEENERING SPECS:
PDF Engineering Specs: MTLX10
